Weber Summit 450 LP Bedienungshandbuch PDF herunterladen

WARNING: Do not try to light this appliance

without reading "Lighting" instructions

section of this manual.

THIS GAS APPLIANCE IS DESIGNED FOR

OUTDOOR USE ONLY.

NOTICE TO INSTALLER: These instructions

must be left with the owner and the owner

should keep them for future use.

FOR YOUR SAFETY

If you smell gas:

1. Shut off gas to the appliance.

2. Extinguish any open flame.

3. Open lid.

4. If odor continues, immediately call your

gas supplier or your fire department.

WARNING: F o l l o w all leak ch e ck pro c e d u r e s

carefully in this manual prior to barbecue

operation. Do this even if barbecue was

dealer assembled.

FOR YOUR SAFETY

1. Do not store or use gasoline or other

flammable vapors and liquids in the

vicinity of this or any other appliance.

2. An LP tank not connected for use shall

not be stored in the vicinity of this or

any other appliance.

SUMMIT 425 & 450

LP Gas Barbecues

Step-By-Step Guide

97464 3/97

Summit 425 LP

Summit 450 LP

1 2 3 4 5 6 ... 15 16

Inhaltsverzeichnis

Seite 1 - SUMMIT 425 & 450

WARNING: Do not try to light this appliancewithout reading "Lighting" instructionssection of this manual.THIS GAS APPLIANCE IS DESIGNED FORO

Seite 2 - SUPPLIES NEEDED

10GENERAL TANK INFORMATIONLP Tank ManufacturerThe LP tank manufacturer is responsible for the materials,workmanship and performance of the tank. If th

Seite 3 - ADD COOKING MODULE

11CONNECT FILLED LPTANKThe hose and regulator are connected in the followingmanner:Slide back the collar of the quick disconnect on the tankvalve. Pus

Seite 4 - MOUNT REGULATOR

12CHECK FOR GAS LEAKSRemove burner control knobs, control paneland front panelFront edge of thecontrol panelPut your fingers under the front edge of t

Seite 5 - INSTALL FLAVORIZER

13Figure 26b)a)ManifoldDANGERDo not use an open flame to check for gasleaks. Be sure there are no sparks or openflames in the area while you check for

Seite 6

14REINSTALL CONTROLPANELFigure 28(a)Front PanelControl PanelYou will need: control panel.Pull igniter buttons up until they stay in the up position.P

Seite 7 - INSTALL BOTTOM TRAY

15REINSTALL BURNERCONTROL KNOBSFigure 29You will need: four burner control knobs.Push on the burner control knobs. Figure 29.INSTALL TOOL HOLDERSFigu

Seite 8 - SURFACES

Seite 9 - FILL LP TANK

Right panel(Summit 450 only)REMOVE PACKAGEDCONTENTS2TOOLS NEEDEDSUPPLIES NEEDED7/16 inch open end or an adjustable wrenchYour LP tank is shipped empty

Seite 10 - GENERAL TANK INFORMATION

3REMOVE PACKAGEDCONTENTS (CONTINUED)1/4-20 keps nut (2)LP tankStainless steel work surface (2)Condiment holder (2)Tool holder (4)Stainless steel botto

Seite 11 - CONNECT FILLED LP

4ADD RIGHT PANELFOR THE SUMMIT 450You will need: right panel.Remove the bolt and nut holding the tank panel in placeat the bottom. Figure 4 (a). Hold

Seite 12 - CHECK FOR GAS LEAKS

5ADD FUEL SCALEFOR THE SUMMIT 450Figure 6(a)(b)Note:The fuel scale is already assembled on the Summit 425.You will need: fuel scale assembly, two 1/4

Seite 13 - (CONTINUED)

6INSTALL STEAM-N-CHIPSSMOKERYou will need: smoker box.Remove the center Flavorizer bar (the one that is not overa burner). Set the handles of the Ste

Seite 14 - REINSTALL FRONT

7Figure 14Slide the bottom tray into the mounting slots under thebottom of the cooking box with the finger grip of the catchpan toward you. Figure 14.

Seite 15 - Front panel

8INSTALL BOTTOMSHELVESFigure 16For the Summit 425, place the stainless steel bottomshelves between the frame supports.For the Summit 450, place the bo

Seite 16

9SET LP FUEL SCALEYou will need: LP tank (empty).Note - For accuracy, the fuel scale must be set with anempty tank.We utilize various LP tank manufac